Dso Setting Storage Menu; Bit Map File Storage Menu - Tenma 72-2650 Operating Manual

72-2650/72-10510/72-8225A /72-8705A/72-8710A user manual
memory location.
Press F4 to store the DSO setting
Attention:
Any storage of the DSO setting will overwrite previous
memory space at the same memory location.
Table 2-15 DSO Setting Storage Menu (Page 2)
Function
Settings Description
Menu
Types (F1)
Setup Select to store a DSO setting
Destination (position of the internal
memory) where the Setup will be
saved. There are 20 sets of internal
Setup(@)
1～20
memory available to storage Setup
navigated by the multipurpose knob.
Press to store a Setup into the
Save[F3]
selected storage memory destination
Press to load a Setup from the
Load[F4]
selected storage memory destination
From the DSO setting storage menu (Page 1)
Use the multi-purpose knob to select the storage memory
location.
Press F4 to load the pre-stored DSO setting.
If there is not a pre-stored DSO setting at the memory
location, there will be a warning "no data in the position"
Below step will guide you to store a bitmap to USB
device:
Insert a USB disk into the "USB Host" interface. If the
USB is connected successfully,you should see the "USB
device install successful" notification on the screen.
Press the Storage button and you will see the following
menu:
Table 2-16 Bit Map File Storage Menu (Page 1)
Function
Settings Description
Menu
Wave Select to store an acquired waveform
Types (F1)
Setup Select to store a DSO setting
39