Measurement; Single Channel (Basic) Measurement - Tenma 72-6802 User Manual

6 Vertical
Use the CH1 VOLTS/DIV knob
adjustment
and CH1 vertical POSITION knob
to adjust the vertical scale and
position of the waveform.
7 Horizontal
Use the CH1 TIME/DIV knob and
adjustment
CH1 horizontal POSITION knob to
adjust the horizontal scale and
position of the waveform.
8 Probe
Adjust the compensation point on the probe so
compensa-
that the waveform becomes square.
tion
Under compensation Right amount
9 Completion Now setting up the oscilloscope is completed. For
more advanced measurements, see page28.
SETUP
Over compensation
27
M
EASUREMENT

Single Channel (Basic) Measurement

Steps
1. Connect the input signal to the
CH1 or CH2 terminal.
2. Select the vertical coupling
between AC (DC components
are blocked) or DC (all signal
components appear).
3. Configure the trigger settings.
For details, see page19.
4. Use the VOLTS/DIV knob and
vertical POSITION knob to
adjust the vertical scale and
position of the waveform.
5. Press the AUTO TIMEBASE
key to automatically adjust the
horizontal scale according to
the input signal.
28
72-6802 User Manual