Table of Contents
Advertisement
Using the Run button
•
There is a [RUN/STOP] button on the front panel. When this button is pressed your
oscilloscope stops acquiring data. To restart data acquisition, press it again.
Auto Setup:
•
Auto Setup can simplify operation.
•
Press [AUTO] and the oscilloscope can automatically adjust the vertical deflection
factor and horizontal time base range according to the amplitude and frequency of
the waveform, so as to ensure stable waveform display.
•
When the oscilloscope is in auto setup mode, the system setup is as in the table
below.
Function
Acquisition mode
Display format
SEC/DIV
VOLT/DIV
Trigger mode
Trigger level
Trigger coupling
Trigger source
Trigger slew rate
Trigger type
Multimeter Measurement
•
Operation instructions: Open the multimeter function menu by pressing [METER].
Functions Menu
Type
Range mode
Range
Trend plot
Zero line value
Sampling
YT
Adjusted according to signal frequency
Adjusted according to signal amplitude
Edge
Mid point of the signal
AC
Set to A but if there is no signal in A and a signal is applied to B it will be
set to B
Rising
Auto
Setup
DC voltage
Select the DC voltage measurement mode.
AC voltage
Select the AC voltage measurement mode.
Resistance
Select the resistance measurement mode.
ON/OFF
Select the ON/OFF measurement mode.
Diode
Select the diode measurement mode.
Capacitance
Select the capacitance measurement mode.
DC current
Select the DC current measurement mode.
AC current
Select the AC current measurement mode.
The multimeter automatically selects an appropriate
Auto
range for measurement. The user manually selects an
Manual
appropriate range for measurement.
Display the current measurement range.
Turn the trend plot function on/off. This function records
ON/OFF
the moving trends of voltage, current, resistance within a
specified period.
When trend plot is on, the zero line value enhances the
trend plot resolution.
Setup
Notes
20
Advertisement
Table of Contents
