72-10510
Warning: please confirm that the DSO has been safely
grounded to avoid hazard.
DSO accessing to signal
①. 72-2650/72-10510/72-8225A /72-8705A/72-8710A
DSO has two input channels with an additional external
trigger input channel. Please check the signal according
to the following steps. Connect DSO probe to CH1 input
terminal and set the attenuation rate switch on the probe
as 10× (Figure 1-5)
6
72-2650/72-10510/72-8225A /72-8705A/72-8710A user manual
Figure 1-5 Setting of Probe Attenuation Rate Switch
②. It is necessary to set probe attenuation coefficient on DSO.
Attenuation coefficient changes the vertical gear position
rate of the instrument, thus making the measurement result
correctly reflect the amplitude of measured signals. Probe
attenuation coefficients are set in the following ways: