Tenma 72-2650 Operating Manual page 48

Press F4 to store the waveform
Remove the USB stick.
Attention:
Any storage of the waveform will overwrite previous
memory space at the same memory location. If "Long"
length data is selected, the data cannot be loaded
back to the DSO display and is only able to load through
Software Application. To load a waveform from the USB
desk, please refer to Chapter 2 of this user manual.
The below steps will guide you on how to store DSO
setting to the internal memory of the DSO:
Press the Storage button and you will see the following
menu.
38
72-2650/72-10510/72-8225A /72-8705A/72-8710A user manual
Table 2-15 Waveform Storage Menu (Page 1)
Function
Settings Description
Menu
Wave Select to store an acquired waveform
Types (F1)
Setup Select to store a DSO setting
Select waveforms from CH1
CH1
channel to be saved
Source(F2)
Select waveforms from CH2 channel
CH2
to be saved
Destination (position of the internal
memory) where the waveform will be
saved. There are 20 sets of internal
1～20
Dest (@)
memory available to store
waveform navigated by the
multipurpose knob.
Save [F4] Store waveform
Next page
Go to the next page
1/2
Press F1 to select Setup.
Use the multi-purpose knob to select the storage