Snmp Traps; Telnet Interface; Figure 8-1. Telnet Interface Example - Windows Command-Line - Comtech EF Data CDM-710 Installation And Operation Manual

CDM-710/L Broadcast Satellite Modem
Ethernet Interface Operation
Type the SNMP Community String into the user-supplied MIB Browser or
Network Node Management software.

8.2.3 SNMP Traps

The CDM-710/L SNMP agent supports both SNMPv1 and v2c. The
Traps file needs to be compiled only if SNMPv1 traps are to be used.
The CDM-710/L has the ability to send out SNMP traps when certain events
occur in the unit. For example, the unit also sends out traps when an alarm or a
fault occurs or clears.
The CDM-710/L supports the following MIB2 SNMPv1 traps and v2 notifications:
• Unit faults
• TX Traffic faults
• RX Traffic faults
• ODU (outdoor unit) faults.
• Clear Stored Events
• Monitor Interface Redundancy Switch State

8.3 Telnet Interface

See Chapter 9. SERIAL INTERFACE OPERATION for detailed information
about using remote command and queries.
Figure 8-1. Telnet Interface Example – Windows Command-line
8–6
MN/CDM710.IOM
Revision 12