CDM-710/L Broadcast Satellite Modem
Front Panel Operation
(CONFIG:) Intfc2 Gigabit Ethernet: Ingress FEC
Use the arrow keys to select Enable or Disable. Press ENTER. Select Enable
to allow the GBEI to perform SMPTE 2022 / Pro-MPEG COP3 error recovery.
Select Disable to direct the GBEI to bypass the SMPTE 2022 / Pro-MPEG COP3
function.
SMPTE has incorporated the per-MPEG Forum into the release of
SMPTE 2022.
(CONFIG:) Intfc2 Gigabit Ethernet: Ingress Str
The top line indicates the active stream. On the bottom line, use the arrow
keys to select IP, Mode, Pri, Red, or Timeout. Press ENTER.
(CONFIG:) Intfc2 Gigabit Ethernet: Ingress Str IP
Use the arrow keys to select 1, 2, or Port. Press ENTER.
(CONFIG:) Intfc2 Gigabit Ethernet: Ingress Str IP 1/2
Where # is the selected stream (1 or 2): Use the arrow keys to select Group
or Source. Press ENTER.
Intfc2 Ingress FEC
Enable Disable
Intfc2 Streams
IP Mode Pri Red Timeout
Intfc2 Multicast Streams
1
2
Port
Intfc2 Address #
Group Source
7–39
Act=1
MN/CDM710.IOM
Revision 12