CDM-710/L Broadcast Satellite Modem
Front Panel Operation
• FPGA Temp Modulator Card – The modulator FPGA is outside its
temperature range.
• Nyq Filter Clipping – There is modulator Nyquist Filter clipping.
7.2.2.2 (Monitor:) Rx_Stats
For DVB-S2 Mode only:
When the demodulator is locked, this screen reports E
rate), ∆F (frequency offset of incoming carrier), and RSL (receive signal level).
For DVB-S or DVB-DSNG Modes only – in these modes, BER monitoring is not
available:
The Link_Margin corresponds, depending on the active mode, as follows:
EsNo=14.0 BUF=050%
EbNo=12.8 BER=1.0E-09
EbNo=12.8 BER=1.0E-09
∆F=-000.2k RSL=-16
∆F=-000.2k RSL=-16
Link_Margin=+10.4
EsNo=16.0
PER=N/A
EbNo=15.1
BER=0.0E+00
EbNo=15.1
BER=0.0E+00
∆F=-000.2k RSL=-16
∆F=-000.4k RSL=-16
Link_Margin=+10.1
7–55
MN/CDM710.IOM
Revision 12
/N
, PER (packet error
b
0
Need help?
Do you have a question about the CDM-710 and is the answer not in the manual?
Questions and answers