Network - Icom IC-9700 Basic Manual

» SET > Connectors > USB (B)/DATA Function
MENU
USB (B) Function
The transceiver has 2 virtual COM ports, A and B.
When connecting to a USB port on your PC, the ports
are virtually named as USB (A) and USB (B).
In this item, sets the function to be assigned to USB
(B).
USB (A) is used for programming, or CI-V operation.
• OFF: Does not assign the function to USB
(B).
• RTTY Decode: Outputs the decoded data of the
RTTY signal.
• DV Data: Inputs or outputs low speed data for
the DV mode.
DATA Function
Sets the function to be assigned to the [DATA] jack.
• OFF: Does not assign the function to the
[DATA] jack.
• RTTY Decode: Outputs the decoded data of the
RTTY signal.
• DV Data: Inputs or outputs low speed data for
the DV mode.
• GPS/Weather: Selected when connecting a GPS
receiver.
• CI-V: Inputs or outputs CI-V commands.
GPS Out
Selects whether or not to output the position data to
USB (B) when the GPS receiver is connected to the
[DATA] jack.
• OFF: Does not output the position data
to USB (B).
• DATA→USB (B): Outputs the position data to USB
(B).
L It is valid when "USB (B) Function" is set to "OFF" or "DV
Data," and "DATA Function" is set to "GPS/Weather."
DV Data/GPS Out Baud Rate
Sets the transfer rate of the DV data and the GPS
output data.
RTTY Decode Baud Rate
Set the data transfer rate of the RTTY decoded
signals.
(Default: OFF)
(Default: GPS/Weather)
(Default: OFF)
(Default: 9600)
(Default: 9600)
8-14

Network

» SET > Network
MENU
DHCP (Valid after Restart)
Turns the DHCP function ON or OFF.
• OFF: Uses a static IP address.
• ON: Uses the DHCP function.
If a DHCP server is in your network
environment, the IP address is automatically
obtained.
IP Address (Valid after Restart)
Sets the static IP address.
Subnet Mask (Valid after Restart)
(Default: 255.255.255. 0 (24 bit))
Sets the subnet mask to connect to your PC or LAN
(Local Area Network), through the Ethernet.
Default Gateway (Valid after Restart) (Default: . . . .)
Sets the Default Gateway of the IC-9700.
When you remotely control the IC-9700, a Default
Gateway setting is required.
Primary DNS Server (Valid after Restart)
Sets the Primary DNS Server address.
2nd DNS Server (Valid after Restart) (Default: . . . .)
If there are two DNS server addresses, sets the
secondary DNS server address.
Network Name
If you are operating the IC-9700 using the optional
RS-BA1, enter a network name of up to 15 characters.
Network Control (Valid after Restart) (Default: OFF)
Selects whether or not to remotely control the IC-9700.
• OFF: Disables remote control of the IC-9700.
• ON: Enables remote control of the IC-9700.
Power OFF Setting (for Remote Control)
Selects whether or not to display the Standby/
Shutdown option dialog after holding down
1 second.
• Shutdown only: Shut down the IC-9700 when you
turn it OFF.
• Standby/Shutdown:
Displays the Standby/Shutdown
option dialog when you turn it OFF.
8
SET MODE
(Default: ON)
(Default: 192.168.0.10)
(Default: . . . .)
(Default: Shutdown only)
for
POWER
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21