Key] - Icom IC-9700 Basic Manual

[KEY]

Connects to a Paddle key or Straight key.
LYou can select the key type.
» SET > KEYER > EDIT/SET >
MENU
CW-KEY SET > Key Type
• Paddle key
• Straight key
_
+
[EXT-SP MAIN] / [EXT-SP SUB]
Connects to external speakers.
3.5 mm, ⅛ in (d)
• Output impedance: 4 ~ 8 Ω
• Output level: More than 2 W at 10% distortion
into an 8 Ω load.
Audio output settings
Internal
speaker
Internal MAIN/SUB
speaker
External OFF
speaker
(MAIN+SUB)
External SUB
speaker
(MAIN)
External MAIN
speaker
(SUB)
* When the [External Speaker Separate] item is set to
"Mix," the audio from both MAIN and SUB are output,
and the internal speaker is deactivated.
» SET > Connectors > External Speaker Separate
MENU
Information
L
• The internal speaker is deactivated while an
external speaker is connected.
• [EXT-SP A] is for the Main band and [EXT-SP B] is
for the Sub band.
» SET > Connectors > EXT-SP MAIN/SUB Mix
MENU
3.5 (d) mm (⅛ in)
dot
com
dash
⅛
3.5 (d) mm ( in)
(3.5 mm, ⅛ in (d))
GND
(When [PHONES] is not in use)
EXT-SP MAIN EXT-SP SUB
OFF OFF
MAIN* SUB*
MAIN* OFF
OFF SUB*
[USB]
USB (1.1/2.0) type B
• Outputting the decoded RTTY data.
• Outputting the demodulated AF signal or 12 kHz IF
signal.
• Inputting the modulation AF signal.
• Interface for remote control by CI-V commands.
• Cloning the setting data using the CS-9700 software.
• Remotely controlling using optional RS-BA1.
L You can change the signal output type and output level.
» SET > Connectors > USB AF/IF Output
MENU
L You can download the USB driver and installation
guide from the Icom website.
http://www.icom.co.jp/world/support/download/firm/
[LAN]
• Time synchronization by an NTP server.
• Outputting the demodulated AF signal or
12 kHz IF signal.
AF
• Remotely controlling using optional RS-
BA1.
• Gateway communication (D-STAR)
• Data communication (DD mode)
L You can select the output signal from AF and IF
signals.
» SET > Connectors > LAN AF/IF Output
MENU
About the LED indication
q LINK/ACT
• Lights when a cable is connected.
• Does not light when a cable is not connected.
• Blinks while communicating.
w Speed
• Lights while communicating in 100BASE-TX.
• Does not light while communicating.
• Blinks while communicating in 10BASE-T, or not
connected.
[DATA]
Connects a PC through a data
communication cable (user supplied),
for data communication, DV Gateway
functions or remote controlling by
CI-V commands.
Using the optional communication cable, you can use
the RS-MS1A application.
Connecting a GPS unit (NMEA compatible) or GPS
output compatible Icom transceiver (Example: ID-
31PLUS) enables the received position data to be
displayed on the IC-9700's display.
13-2
CONNECTOR INFORMATION
2.5 (d) mm
13
1
2
3
4
5
6
7
8
9
10
11
w q
12
13
14
15
16
17
18
19
20
21
GND TxD
RxD