D Entering A Band Edge - Icom IC-9700 Basic Manual

3
BASIC OPERATION
Setting the frequency (Continued)

D Entering a Band Edge

When "ON (User)" or "ON (User) & TX Limit" is
selected on the "Band Edge Beep" screen, you can
enter a total of 30 band edge frequency pairs.
L Initially, all Ham band frequencies are entered into the
first 3 band edges. Therefore, you must first edit or delete
them to enter a new band edge.
L You cannot enter an overlapping frequency, or a
frequency that is out of the preset Ham band frequencies.
LBand edges are entered from the lower frequency first.
1. Open the "Band Edge Beep" screen.
» SET > Function > Band Edge Beep
MENU
2. Select "ON (User)" or "ON (User) & TX Limit."
L If you select "ON (User) & TX Limit," you can limit
transmission to within the entered frequency range.
3. Select "User Band Edge."
• Opens the "User Band Edge" screen.
Editing a Band Edge
You can edit a band edge entered as a default or
when entering a new band edge.
1. On the FUNCTION set screen, select "User Band
Edge."
2. Touch the band edge you want to edit for 1
second.
(Example: 2: 430.000.000 – 440.000.000 MHz)
3. Edit the lower band edge frequency, then touch [ENT].
(Example: 430.1)
Entry example:
4. Edit the upper band edge frequency, then touch
[ENT]. (Example: 439.1)
Entry example: [4] [3] [9]
Rotate
Push
• The edited band edge is saved and returns to the
previous screen.
TIP:
You can also edit the frequency by rotating
.
MULTI
Rotate
Push
Rotate
Push
3-7
[•], [1], [ENT]
[•], [9], [ENT]
MAIN DIAL
or