Save Set Screen; Load Set Screen; Save Contents; Voice Rx Memory - Icom IC-7850 Instruction Manual

10
USING AN SD CARD OR USB FLASH DRIVE
SD/USB-Memory set screen (Continued)
■
D Save set screen

SAVE Contents

Select the content to be saved onto the SD card or
USB flash drive.
• All: All memories and settings are saved onto the
card or flash drive.
• Select: The memories and settings are saved onto
the card or flash drive, depending on the fol-
lowing settings.
Memory & Settings
Select to save the Memory channel contents and the
settings.
• YES: Saves
Voice TX Memory
Select whether or not to save the Voice TX memory
content.
• YES: Saves
• NO: Does not save

Voice RX Memory

Select whether or not to save the Voice RX memory
content.
• YES: Saves
• NO: Does not save
SAVE Form
Selects the file saving format between "Now Ver" and
"Old Ver."
To save settings and memory contents for backup or
copying to another IC-7850, you must save the data in the
firmware version format that matches the target IC-7850.
Select "Now Ver" for the current version, or "Old Ver
(xxx - xxx)" for the previous versions.
• The previous versions are shown in brackets, and you can
select the desired version by rotating [MAIN DIAL]. The file
will be saved in the selected version.
See page 17-2 for confirming the
IC-7850.
• Now Ver: Saves the file in the current firmware ver-
sion format.
• Old Ver: Saves the file in the firmware version for-
mat shown in brackets.
NOTE:
• You cannot write setting file that is saved in the
current version format to an older firmware version
IC-7850.
• If the settings are saved in an older version format,
the items added in later version are not saved.
(Default: All)
(Default: YES)
(Default: YES)
(Default: NO)
(Default: Now Ver)
firmware version of the
D Load set screen
Load Contents
Select the contents to be loaded from the SD card or
USB flash drive to the transceiver.
• All: All memories and settings of the file are load-
ed into the transceiver.
• Select: The specified memories and settings of the
file are loaded into the transceiver, depending
on the following settings.
Antenna Memory
Select whether or not to load the antenna memory.
• YES: Loads
• NO: Does not load
REF IN/OUT, REF Adjust, Filter CAL
Select whether or not to load the REF signal IN/OUT
settings, REF adjustment values, and roofing filter cali-
bration adjustment values.
• YES: Loads
• NO: Does not load

Network Settings

Select whether or not to load the network settings.
• YES: Loads
• NO: Does not load
CI-V Address
Select whether or not to load the CI-V address set-
tings.
• YES: Loads
• NO: Does not load
Other Memory & Settings
Select to load the Memory channel contents and the
settings.
• YES: Loads
Voice TX Memory
Select whether or not to load the Voice TX memory
content.
• YES: Loads
• NO: Does not load
Voice RX Memory
Select whether or not to load the Voice RX memory
content.
• YES: Loads
• NO: Does not load
10-4
(Default: Select)
(Default: NO)
(Default: NO)
(Default: NO)
(Default: NO)
(Default: YES)
(Default: YES)
(Default: NO)