Others - Icom IC-9700 Basic Manual
Vhf/uhf all mode transceiver
Hide thumbs
Also See for IC-9700:
- Advanced manual (173 pages) ,
- Service manual addendum (163 pages) ,
- Service manual (93 pages)
Table of Contents
Advertisement
8
SET MODE
SD Card (Continued)
» SET > SD Card
MENU
Unmount
Unmounts the SD card.
Before you remove a card when the transceiver is ON,
be sure to electrically unmount it. Otherwise the data
may be corrupted or deleted.
Others
» SET > Others > Information
MENU
Version
Displays the transceiver firmware's version number.
MAC Address
Displays the transceiver's MAC address.
» SET > Others > Clone
MENU
Clone Mode
Selects to enter the clone mode to read or write the
CS-9700 data from or to the PC.
LRestart the IC-9700 to cancel the clone mode.
» SET > Others
MENU
Touch Screen Calibration
Touch to adjust the touch screen.
LSee the Advanced Manual for details.
» SET > Others > Reset
MENU
Partial Reset
Resets operating settings to their default values (VFO
frequency, VFO settings, menu contents) without
clearing the items below:
• Memory channel contents
• Call sign memories
• Message contents
• DTMF memory contents
• GPS memory contents
• Repeater list contents
• Network settings
• REF Adjust
• Fixed Edges
• Allowed call sign list contents
LSee "Resetting" (p. 10-2) for details.
All Reset
Clears all data and returns all settings to their factory
defaults.
Memory channel contents, filter setting and so on
will all be cleared, so you will need to rewrite your
operating settings.
LSee "Resetting" (
8-19
) for details.
p. 10-2
- Quick Links:
- Rear Panel
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IC-9700 and is the answer not in the manual?
Questions and answers
Hi I cannot get my ic7900 to work on independe freq and green light sub is on plus I got main rev and sub in my screen .and cannot get my transceiver work with DUB function.on 2 meter please can you help ?
To resolve the issue where the Icom IC-9700 is not working on an independent frequency with the green Sub light on and the Dualwatch (DUB) function not functioning on 2 meters:
1. Confirm Dualwatch is Enabled: Hold down the OFF button for 1 second to turn the Dualwatch function ON. This activates independent monitoring of both Main and Sub bands.
2. Select the Proper Band: Touch the grayed frequency readout to select the active band. Ensure the Main and Sub bands are set to different frequencies and not both on 2 meters, as the same frequency cannot be set on both bands.
3. Check Band Settings: Ensure that the Sub band is not set to the same frequency or band as the Main. The IC-9700 supports independent operation on different bands, but not the same frequency on both Main and Sub.
4. Verify TX is on Main Band: Transmission is only possible on the Main band (except in Split Frequency mode), so ensure the Main band is the one you intend to transmit on.
5. Check for Mode Compatibility: Some functions only apply to the selected band and mode. Confirm that the correct mode (FM, SSB, etc.) is selected for the band in use.
Following these steps should allow independent frequency operation with Dualwatch enabled.
This answer is automatically generated