Timer.measure.t() - Keithley 3700A Series Reference Manual

Section 11: TSP command reference
As an example, to set bit B1 of the system summary 5 enable register, set
status.system5.enable = status.system5.NODE57.
In addition to the above constants, enableRegister can be set to the numeric equivalent of the bit
to set. To set more than one bit of the register, set enableRegister to the sum of their decimal
weights. For example, to set bits B1 and B4, set enableRegister to 18 (which is the sum of 2 +
16).
Bit
Binary value
Decimal
Weights
Bit
Binary value
Decimal
Weights
Example 1
enableRegister = status.system5.NODE57 +
status.system5.NODE60
status.system2.enable = enableRegister
Example 2
-- decimal 18 = binary 0000 0000 0001 0010
enableRegister = 18
status.system5.enable = enableRegister
Also see
status.system4.*
System summary bit (System register)

timer.measure.t()

This function measures the elapsed time since the timer was last reset.
Type TSP-Link accessible
Function Yes
Usage
time = timer.measure.t()
time
11-404
B7 B6
0/1 0/1
128 64
7 6
(2 ) (2 )
B15 B14
0/1 0/1
32,768 16,384
15 14
(2 ) (2 )
(on page 11-400)
(on page C-5)
Affected by
The elapsed time in seconds (1 µs resolution)
Series 3700A System Switch/Multimeter Reference Manual
B5 B4 B3
0/1 0/1 0/1
32 16 8
5 4 3
(2 ) (2 ) (2 )
B13 B12 B11
0/1 0/1 0/1
8,192 4,096 2,048
13 12 11
(2 ) (2 ) (2 )
Uses constants to set bits B1 and B4 of
the system summary 5 enable register.
Uses a decimal value to set bits B1 and
B4 of the system summary 5 enable
register.
Where saved
B2 B1 B0
0/1 0/1 0/1
4 2 1
2 1 0
(2 ) (2 ) (2 )
B10 B9 B8
0/1 0/1 0/1
1,024 512 256
10 9 8
(2 ) (2 ) (2 )
Default value
3700AS-901-01 Rev. D/June 2018