Localnode.passwordmode - Keithley 3700A Series Reference Manual

Series 3700A System Switch/Multimeter Reference Manual
Example
localnode.password = "N3wpa55w0rd"
Also see
lan.reset()

localnode.passwordmode

localnode.passwordmode
This attribute stores the remote access password enable mode.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
mode = localnode.passwordmode
localnode.passwordmode = mode
mode
Details
This attribute controls if and where remote access passwords are required. Set this attribute to one of
the values below to enable password checking:
•
localnode.PASSWORD_NONE or 0: Disable passwords everywhere
•
localnode.PASSWORD_WEB or 1: Use passwords on the web interface only
•
localnode.PASSWORD_LAN or 2: Use passwords on the web interface and all LAN interfaces
•
localnode.PASSWORD_ALL or 3: Use passwords on the web interface and all remote command
interfaces
When using this command from a remote node, localnode should be replaced with the node
reference, for example node[5].passwordmode.
Example
mode = localnode.PASSWORD_WEB
localnode.passwordmode = mode
Also see
localnode.password
3700AS-901-01 Rev. D/June 2018
(on page 11-265)
(on page 11-287)
Affected by
Not applicable
The remote password enable mode
(on page 11-286)
Section 11: TSP command reference
Changes the remote interface password to
N3wpa55w0rd.
Where saved Default value
Nonvolatile memory 1 (localnode.PASSWORD_WEB)
Sets value of mode to PASSWORD_WEB.
Allows use of passwords on the web interface only.
11-287