Scan.measurecount - Keithley 3700A Series Reference Manual

Section 11: TSP command reference

scan.measurecount

This attribute sets the number of iterations performed when a scanning measurement is requested.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
count = scan.measurecount
scan.measurecount = count
count
Details
Use this attribute to indicate how many measurements to make on a step when measurements are
needed. This sets the measurement count in the trigger model. During a scan, the Series 3700A
iterates through the sequence event detector and measurement action of the trigger model count
times. After performing count iterations, the Series 3700A returns to check the scan count.
This must be set before the scan is started. Once set, it applies to all scan steps in the list, including
scan steps that exist in the list and any that are added before the scan is started.
All steps take the same number of measurements. When taking multiple measurements, the
measurements may be taken as quickly as possible based on the configuration
(scan.trigger.measure.stimulus = 0) or they may be paced by a trigger
(scan.trigger.measure.stimulus is nonzero).
Example
scan.measurecount = 5
Also see
scan.create()
Scanning and triggering
11-320
Affected by
Reset
Scan reset
Recall setup
The count value being used or read; valid range is 1 to 450000
(on page 11-315)
(on page 5-23)
Series 3700A System Switch/Multimeter Reference Manual
Where saved
Create configuration script
Save setup
Sets the measurement count to 5.
3700AS-901-01 Rev. D/June 2018
Default value
1