Dmm.filter.count - Keithley 3700A Series Reference Manual

Section 11: TSP command reference

dmm.filter.count

This attribute sets the filter count setting for the selected DMM function.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
value = dmm.filter.count
dmm.filter.count = value
value
Details
The number of measured readings that will yield one filtered measurement when filtered
measurements are enabled.
The filter count setting only applies when dmm.func is set to one of the following:
•
"accurrent"
•
"acvolts"
•
"commonsideohms"
•
"dccurrent"
•
"dcvolts"
•
"fourwireohms"
•
"temperature"
•
"twowireohms"
If you query the setting for any other function, nil is returned.
The filter count setting is saved with the dmm.func function setting, so if you use another function,
then return to the previous function, the filter count setting you set previously is retained.
An error is generated if:
•
You send the setting for any other function.
•
The value is out of range.
Example
dmm.func = "twowireohms"
dmm.filter.count = 5
dmm.filter.enable = dmm.ON
Also see
dmm.configure.set()
dmm.configure.recall()
dmm.filter.enable
dmm.filter.type
11-174
Affected by
Reset
DMM reset
Recall setup
The filter count setting from 1 to 100
(on page 11-166)
(on page 11-165)
(on page 11-175)
(on page 11-176)
Series 3700A System Switch/Multimeter Reference Manual
Where saved
Create configuration script
Save setup
Sets the filter count for 2-wire ohms to 5 and
enables filtered measurements.
3700AS-901-01 Rev. D/June 2018
Default value
10