Dmm.reset() - Keithley 3700A Series Reference Manual

Series 3700A System Switch/Multimeter Reference Manual
Also see
dmm.configure.recall()
dmm.configure.set()
dmm.func
dmm.measure()
dmm.rel.acquire()
dmm.rel.enable

dmm.reset()

Resets the DMM functions and attributes in the instrument, as indicated by the parameter.
Type TSP-Link accessible
Function Yes
Usage
dmm.reset(scope)
scope
Details
When the scope is set to active, this command resets the DMM attributes for the active function to
factory default values. The settings for other functions are unchanged.
When the scope is set to all, this command resets the DMM functions and attributes to factory
default settings.
This function does not affect the DMM configurations (dmm.setconfig() and dmm.getconfig()).
The factory default settings are:
•
The selected DMM function is set to "dcvolts".
•
The DMM settings are set to the defaults for "dcvolts".
•
All attribute settings for other functions are set to factory default settings.
To reset the entire instrument to factory default settings, use the reset command.
Example
dmm.func = "temperature"
dmm.reset("active")
print(dmm.func)
dmm.reset("all")
print(dmm.func)
Also see
dmm.func
dmm.getconfig()
dmm.setconfig()
reset() (on page 11-308)
3700AS-901-01 Rev. D/June 2018
(on page 11-165)
(on page 11-166)
(on page 11-179)
(on page 11-205)
(on page 11-216)
(on page 11-217)
Affected by
A string equaling "active" to set the active function only to factory default
settings or "all" to set all functions back to factory default settings
(on page 11-179)
(on page 11-181)
(on page 11-227)
Where saved
Set the DMM function to temperature.
Perform a reset on temperature only.
Check the function after resetting only temperature.
Perform a reset on all DMM functions.
Check the function after resetting all DMM functions. Output:
temperature
dcvolts
Section 11: TSP command reference
Default value
11-219