Scan.trigger.sequence.clear() - Keithley 3700A Series Reference Manual

Series 3700A System Switch/Multimeter Reference Manual
Trigger event IDs
Trigger event ID
scan.trigger.EVENT_SCAN_READY or 24
scan.trigger.EVENT_SCAN_START or 25
scan.trigger.EVENT_CHANNEL_READY or 28
scan.trigger.EVENT_MEASURE_COMP or 56
scan.trigger.EVENT_SEQUENCE_COMP or 50
scan.trigger.EVENT_SCAN_COMP or 26
scan.trigger.EVENT_IDLE or 27
schedule.alarm[N].EVENT_ID or 37 to 38
Use one of the text trigger event IDs (for example, digio.trigger[N].EVENT_ID) to set the
stimulus value rather than the numeric value. Doing this will make the code compatible for future
upgrades.
Example
scan.trigger.measure.stimulus = scan.trigger.EVENT_CHANNEL_READY
Sets the trigger stimulus of the measurement event detector to the channel ready event.
Also see
scan.trigger.sequence.stimulus
Scanning and triggering

scan.trigger.sequence.clear()

This function clears the sequence event detector.
Type TSP-Link accessible
Function Yes
Usage
scan.trigger.sequence.clear()
Details
This function sets the sequence event detector to the undetected state.
Example
scan.trigger.sequence.clear()
Also see
Scanning and triggering
3700AS-901-01 Rev. D/June 2018
(on page 11-336)
(on page 5-23)
Affected by
(on page 5-23)
Section 11: TSP command reference
Description
Scan ready event.
Scan start event.
Channel ready event.
Measure complete event.
Sequence complete event.
Scan complete event.
Idle event.
Trigger event generated by the alarm N.
Where saved Default value
Clears the sequence event detector.
11-335