Lan.nagle; Lan.reset(); Lan.restoredefaults() - Keithley 3700A Series Reference Manual

Series 3700A System Switch/Multimeter Reference Manual

lan.nagle

This attribute controls the state of the LAN Nagle algorithm.
Type TSP-Link accessible
Attribute (RW) Yes
Usage
state = lan.nagle
lan.nagle = state
state
Details
This attribute enables or disables the use of the LAN Nagle algorithm on transmission control protocol
(TCP) connections.
Also see

lan.restoredefaults()

lan.reset()

This function resets the LAN interface.
Type TSP-Link accessible
Function Yes
Usage
lan.reset()
Details
This function resets the LAN interface. It performs the commands lan.restoredefaults() and
lan.applysettings().
Also see
lan.applysettings()
lan.restoredefaults()
lan.restoredefaults()
This function resets LAN settings to default values.
Type TSP-Link accessible
Function Yes
Usage
lan.restoredefaults()
3700AS-901-01 Rev. D/June 2018
Affected by
Power cycle
The state of the Nagle algorithm:
▪
1 or lan.ENABLE: Enable the LAN Nagle algorithm for TCP
connections
▪
0 or lan.DISABLE: Disable the Nagle algorithm for TCP connections
(on page 11-265)
Affected by
(on page 11-258)
(on page 11-265)
Affected by
Section 11: TSP command reference
Where saved Default value
Not saved 0 (lan.DISABLE)
Where saved Default value
Where saved Default value
11-265