Frequency Inverter Identification; Inverter Model - WEG CFW100 Programming Manual

6 FREQUENCY INVERTER IDENTIFICATION

In order to check the inverter model, see the code on the product nameplate on the side of the inverter.
Once verified the identification code of the model of the inverter, refer to Chapter 2 General Information of the user's
manual of the frequency inverter.
The parameters related to the inverter model are shown below. They are modified according to the model and
version of the inverter and must comply with the data read on the product nameplate.

6.1 INVERTER MODEL

P023 - Main SW Version
Range: 0.00 to 99.99
Properties: ro
Description:
It indicates the software version of the main microprocessor on the control board.
P029 - Power HW Configuration
Range: 0 = Not identified
1 = 1.6A/110V
2 = 2.6A/110V
3 = 4.2A/110V
4 = 6.0A/110V
5 = 1.6A/220V
6 = 2.6A/220V
7 = 4.2A/220V
8 = 6.0A/220V
9 = 7.3A/220V
10 = 10.0A/220V
11 = 15.2A/220V
12 to 19 = Reserved
20 = 1.1A/380V
21 = 1.8A/380V
22 = 2.6A/380V
23 = 3.5A/380V
24 = 4.8A/380V
25 = 6.5A/380V
26 = 8.2A/380V
27 = 10.0A/380V
28 = 12.0A/380V
29 = 15.0A/380V
Properties: ro
Description:
This parameter identifies the inverter model, distinguishing the supply voltage and the rated current according to
Table 6.1 on page 6-2.
From P029, the inverter determines the current and voltage parameters depending on the model identification. On
the other hand, this action is only effected at the moment of the factory standard load (P204 = 5 or 6).
FREQUENCY INVERTER IDENTIFICATION
Micro Mini Drives | 6-1
6