Control Configuration - WEG CFW100 Programming Manual

MOTOR CONTROL
P580 - Fire Mode Configuration
Range:
Properties:
Description:
This parameter defines how the Fire Mode functionality will work in the frequency inverter.
Option
0 Fire Mode function is inactive
Fire Mode function is active. When the DIx set to Fire Mode is opened, "A211" will be shown on the HMI and no
1
changes will be made to the speed reference or to the inverter control
Fire Mode function is active. When the DIx set to Fire Mode is opened, "A211" will be shown on the HMI and the Speed Reference
2
will be set automatically to maximum (P134) value. The motor will accelerate to this new reference
3 Reserved
Fire Mode function is active. When the DIx set to Fire Mode is opened, "A211" will be shown on the HMI and the pulses
4
in the output will be disabled. Motor will coast to stop
P582 - Fire Mode Auto-reset Adjustable
Range:
Properties:
8
Description:
This parameter defines how the auto-reset functionality will work in Fire Mode when a critical fault occur (DC Link
Overvoltage (F022) and Overcurrent/Short-circuit (F070)).
Option
8.1.8 Control Configuration
P397 - Control Config
Range:
Properties:
Description:
The bits of parameter P397, as shown in
the control of the induction motor, such as:
8-16 | Micro Mini Drives
0 = Inactive
1 = Active
2 = Active / P134
3 = Reserved
4 = Active / General Disable
cfg
Table 8.3: Options for the parameter P580
0 = Limited
1 = Unlimited
cfg
Table 8.4: Options for the parameter P582
0 Limited. Auto-reset works as defined in P340 parameter
Unlimited. The auto-reset happens after 1s of a critical failure detection regardless of the
1
value set in P340
0 to F (hexa)
Bit 0 = Slip Compens. Regen.
Bit 1 = Dead Time Comp.
Bit 2 = Is Stabilization
Bit 3 = P297 reduction in A050
cfg
Table 8.5 on page
Description
Description
8-17, enable a series of internal options to configure