Table of Contents
Advertisement
www.weg.net
3. SHIPMENT, STORAGE AND HANDLING
Check the conditions of the motor immediately upon receipt. Where any damage is noticed, this
must be reported in writing to the transportation company, and immediately communicated to the
insurance company and to WEG. In this case, no installation job can be started before the detected
problem has been solved.
Check if the nameplate data matches the invoice data and the environmental conditions in which the
motor will be installed. If the motor is not immediately installed, it must be stored in a clean and dry
room protected against dust, vibrations, gases and corrosive agents, and with relative humidity not
exceeding 60%.
If the motors are stored for more than two years, it is recommended to change the bearings, or to
remove, wash, inspect and relubricate them before the motor is started.
DANGER!
Always handle the motor carefully in order to prevent personal injuries and impacts
g
that could damage the bearings.
Do not lift and/or carry the product holding by the input cables.
g
When available, use only the eyebolts to lift the motor. However these eyebolts are
g
designed for the motor weight only. Thus never use these eyebolts to lift the motor
with additional loads coupled to it. For multimounting motors (with removable feet/
base), the eyebolts must be positioned according to the motor mounting position so
that the lifting angle is vertically aligned (lifting at 0°).
Additional information regarding the maximum allowable angle-of-inclination is indi-
g
cated in the general manual available on the website www.weg.net.
4. IDENTIFICATION LABELS
There is one nameplate with general product information on the WECM / Emerald eZA product
that is affixed to the side of the motor frame and one label with basic electronic information that is
affixed to the drive (back cover).
4 | WECM / Emerald eZA Manual
Figure 1 - Drive label
Advertisement
Table of Contents
