WEG CFW100 Programming Manual page 33

ABOUT THE HMI
It is the initial status of the HMI after the successful power-up (without fault,
alarms or undervoltages)
Press the key to go to level 1 of the setting mode - parameter selection.
Pressing any other key will also change to the setting mode
Level 1:
This is the first level of the setting mode. The number of the parameter is
shown on the main display.
Use the and
Press the key to go to level 2 of the setting mode - modification of the
parameter content
Level 2:
The content of the parameter is shown on the main display
Use the and
parameter
4
Press the key to confirm the modification (save the new value). After the
change is confirmed, the HMI returns to level 1 of the setting mode
✓
NOTE!
When the inverter is in the alarm state, the main display indicates the number of the alarm in
the format Axxx.The browsing is allowed after pressing the
is displayed on the unit of measurement display, flashing until the situation causing the alarm is solved.
4-2 | Micro Mini Drives
Table 4.1: HMI operating modes
Start-up Mode
Setting Mode
keys to find the desired parameter
keys to configure the new value for the selected
Monitoring
Setting
level 1
Setting
level 2
key, and then the indication "A"