Bluetooth - WEG CFW100 Programming Manual

P312 - Serial Protocol
Range: 0 to 1 = Reserved
2 = Modbus RTU Slave
3 to 4 = Reserved
5 = ModBus RTU Master
Properties: cfg
P313 - Action for Comminic. Error
Range: 0 = Inactive
1 = Ramp Stop
2 = General Disable
3 = Go to LOC
4 = LOC Keep Enab.
5 = Cause Fault
P314 - Serial Watchdog
Range: 0.0 to 999.0 s
Properties: cfg
P316 - Serial Interf. Status
Range: 0 = Inactive
1 = Active
2 = Watchdog Error
Properties: ro
Description:
These parameters are used for configuration and operation of the RS-232, RS-485, USB and Bluetooth. For a
description detailed, refer to the Modbus RTU, user's manual, available for download on the website:
www.weg.net.

12.3 BLUETOOTH

See below the parameters to configure and operate the Bluetooth interface. For the correct configuration of this
interface, it is necessary to configure properly the parameters of the
P770 - Blueooth Device Name
Range: 0 to 9999
Description:
This parameter identifies the bluetooth device with a friendly name on the network. This name is limited to the four
digits available on the inverter display.
The default value of this parameter is the last four digits of the inverter serial number.
COMMUNICATION
Section 12.2 SERIAL on page
Micro Mini Drives | 12-3
12-2.
12