Indications - WEG CFW100 Programming Manual

✓
NOTE!
In order to upload the user parameters (P204 = 7), the factory default must be uploaded first (P204
= 5 or 6).

5.2 INDICATIONS

P205 - Main Display Parameter
Range: 0 to 999
Description:
This parameter defines which parameter will be viewed on the HMI when the motor is enabled after initialization.
P207 - Bar Graph Parameter
Range: 0 to 999
Description:
This parameter defines which parameter will be shown on the HMI bar graph.
P208 - Ref. Scale Factor
Range: 1 to 9999
Description:
This parameter allows adjusting the scale of the parameter speed reference P001 and output (motor) speed P002
so as to convert the indication of frequency values applied to the motor (Hz) into angular speed in "rpm" or a
proportional value in "%", for instance.
Together with the unit in P209 and the decimal places in P210, the rated reference P208 defines the speed indication
on the inverter HMI. According to the factory default of those parameters, the preset scale on the inverter is in "Hz"
and with a decimal place (60.0 Hz or 50.0 Hz). On the other hand, by setting P208 = 1800 or 1500, P209 = 7 and
P210 = 0, a scale in "rpm" with no decimal places is defined (1800 rpm or 1500 rpm).
P209 - Ref. Eng. Unit
P510 - SoftPLC Eng. Unit
Range: 0 to 1 = Without unit
2 = Volt (V)
3 = Hertz (Hz)
4 = Without unit
5 = Percent (%)
6 = Without unit
7 = Rotation/min. (rpm)
Description:
These parameters select the engineering unit that will be displayed on the HMI. P209 is linked to parameters P001
and P002. P510 is linked to the SoftPLC user's parameters. That is, any SoftPLC user's parameter linked to the
SoftPLC engineering unit will be dispalyed in this format.
HMI
Micro Mini Drives | 5-3
5