Fitting Cpx Terminals With Cpa Or Mpa Pneumatics Onto A Hat Rail - Festo CPX Electronic Manual

2. Fitting

2.3.2 Fitting CPX terminals with CPA or MPA pneumatics onto a hat rail

Festo P.BE−CPX−SYS−EN en 0503b
For fitting the CPX terminal onto a hat rail you will require
fitting kit type CPX−CPA−BG−NRH. This kit consists of 3 M4x10
screws and 3 clamping elements.
Caution
Hat rails fitted with CPA14 valve terminals can break if they
are subjected to vibration which exceeds the following
values:
0.15 mm path at 10...58 Hz
2 g acceleration at 58...150 Hz
This can cause damage to the CPA valve terminal or to your
machine or system.
Use the wall fitting for CPA14 valve terminals.
·
Caution
A hat−rail fitting without a hat−rail clamping unit is not
permitted.
If the terminal is fitted in a sloping position or if it is sub
·
jected to vibration, secure the hat−rail clamping unit
additionally
against sliding down and against unintentional
the locking screws (see Fig. 2/9, item 3)
with the locking screws intended for this purpose
(item 6).
2−19