Table of Contents
Advertisement
Removing the TPM
1
Locate the TPM connector on the system board.
2
Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
3
Slide the TPM module out from its connector.
4
Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
5
Pull the plastic rivet out of its slot on the system board.
Installing the TPM
Steps
1
To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2
Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3
Press the plastic rivet until the rivet snaps into place.
Figure 104. Installing the TPM
Next steps
1
Install the system
board.
2
Follow the procedure listed in
Initializing TPM for BitLocker users
Initialize the TPM.
For more information, see .
The TPM Status changes to Enabled, Activated.
Initializing the TPM 1.2 for TXT users
1
While booting your system, press F2 to enter System Setup.
2
On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3
From the TPM Security option, select On with Pre-boot Measurements.
4
From the TPM Command option, select Activate.
After working inside your
system.
Installing and removing system components
155
Advertisement
Table of Contents
