Configuring Et 200S In The Simatic Manager - Siemens SIMATIC ET 200S Operating Instructions Manual

Brief instructions on commissioning ET 200S
2.2 Commissioning on PROFINET IO
2.2.3

Configuring ET 200S in the SIMATIC manager

Proceed as follows
1. Start SIMATIC Manager and create a new project with an IO controller
2. Open the "Properties - Ethernet Interface" window in the HW Config and create a subnet
3. Take the IM151-3 PN from the ET 200S catalog of the hardware catalog and insert it on
4. Drag the individual ET 200S modules from the hardware catalog to the configuration
Table 2- 2 Configuration table in HW Config for PROFINET IO
Module
0 6ES7151-3AA20-0AB0 IM151-3 PN
1 6ES7138-4CA01-0AA0 PM-E DC24V
2 6ES7131-4BB01-0AB0 2DI DC24V
3 6ES7131-4BB01-0AB0 2DI DC24V
4 6ES7131-4BB01-0AB0 2DI DC24V
5 6ES7131-4BB01-0AB0 2DI DC24V
6 6ES7138-4CA01-0AA0 PM-E DC24V
7 6ES7132-4BB01-0AB0 2DO DC24V
8 6ES7132-4BB01-0AB0 2DO DC24V
9 6ES7132-4BB01-0AB0 2DO DC24V
10 6ES7132-4BB01-0AB0 2DO DC24V
1. Set the following parameters:
2. Compile and save the configuration.
34
(e g., CPU 317-2 PN/DP). For this project, create the OB 1, the OB 82, the OB 83 and the
OB 122.
e. g. Ethernet (1).
Ethernet(1):PROFINET IO System (100).
table.
Order No.:
– In the IO device properties dialog box for the PM-E DC24V, module 1 (in the
configuration table)
Diagnostics: Missing load voltage
– In the IO device properties dialog box for the 2 DO DC24V, Module 7 (in the
configuration table)
Diagnostics: Wire break A0
I address Q address
0
1
2
3
0
1
2
3
Operating Instructions, 08/2008, A5E00515771-06
Comment
Power module
Bytes 0.0 and 0.1
Bytes 1.0 and 1.1
Bytes 2.0 and 2.1
Byte 3.0 and 3.1
Power module
Bytes 0.0 and 0.1
Bytes 1.0 and 1.1
Bytes 2.0 and 2.1
Byte 3.0 and 3.1
ET 200S