Siemens SIMATIC ET 200S Operating Instructions Manual page 58

Installing
4.4 Installing the terminal modules TM-C for COMPACT modules
Removing a terminal module for COMPACT modules
The terminal module is wired, and there are other terminal modules to the right.
The terminal module for COMPACT modules can only be removed when there is
approximately 8 mm space between it and the next terminal module (shift the modules if
necessary).
1. Switch off the supply voltage on the terminal module for COMPACT modules or for the
2. Disconnect the wiring on the terminal module for COMPACT modules.
3. Use a screwdriver to press down the slider on the interface module for COMPACT
4. Press down on the slider while taking the terminal module off the mounting rail.
①
Note
The terminal box can be replaced without first removing the terminal module for COMPACT
modules.
58
power module, if applicable.
modules until the mechanism stops, then move the terminal module to the left.
Note:
– The slider is located underneath the terminal module.
– This step is not required if no other terminal modules are located to the right of the
terminal module for COMPACT modules.
Figure 4-6 Removing a terminal module for COMPACT modules
Slide
Operating Instructions, 08/2008, A5E00515771-06
ET 200S