Siemens SIMATIC ET 200S Operating Instructions Manual page 110

Commissioning
6.2 Commissioning on PROFIBUS DP
Configuration table and address space
The user is free to select the byte addresses of the inputs and outputs (if the configuration
software supports this). The bit addresses result automatically from the sequence of the
grouped modules.
The following table shows which modules have been grouped and the corresponding
address space.
Table 6- 1 Configuration table and address space
Slot Module
1 6ES7138-4CA01-0AA0 PM-E DC24V
2 6ES7131-4BB01-0AB0 2DI DC24V
3 6ES7131-4BB01-0AB0* 2DI DC24V
4 6ES7134-4FB01-0AB0 2AI U
5 6ES7135-4GB01-0AB0 2AO I
6 6ES7131-4BD01-0AA0* 4DI DC24V
7 6ES7132-4BD01-0AA0 4DO DC24V
8 6ES7132-4BB01-0AB0* 2DO DC24V
9 6ES7132-4HB01-0AB0* 2DO Rel.
10 6ES7134-4FB01-0AB0 2AI U
11 6ES7135-4GB01-0AB0 2AO I
12 6ES7138-4CA01-0AA0 PM-E DC24V
13 6ES7132-4BB31-0AB0 2DO DC24V
14 6ES7132-4BB31-0AB0* 2DO DC24V
15 6ES7138-4CB11-0AB0 PM-E AC230
16 6ES7132-4FB01-0AB0* 2DO 230V
17 6ES7132-4FB01-0AB0* 2DO 230V
18 3RK1903-0BA00 PM-D
19 3RK1301-xxB00-0AA0 DS
20 3RK1301-xxB00-0AA0 *DS
21 3RK1301-xxB00-0AA0 DS
110
Grouping I/O address
Inputs
--- ---
yes 0.0 to 0.1
0.2 to 0.3
No 1 to 4
No
yes 0.4 to 0.7
yes
No 5 to 8
No
--- ---
yes
yes
--- ---
yes
yes
--- ---
yes 9.0 to 9.3
9.4 to 9.7
yes 10.0 to 10.3
Operating Instructions, 08/2008, A5E00515771-06
Outputs
---
0 to 3
4.0 to 4.3
4.4 to 4.5
4.6 to 4.7
5 to 8
---
9.0 to 9.1
9.2 to 9.3
---
9.4 to 9.5
9.6 to 9.7
---
10.0 to 10.3
10.4 to 10.7
11.0 to 11.3
ET 200S