Replacing The Terminal Box On The Terminal Module - Siemens SIMATIC ET 200S Operating Instructions Manual

Installing

4.7 Replacing the terminal box on the terminal module

Installing pluggable bridges
1. Pull the labeling strips out of the additional terminals.
2. Insert the pluggable bridge between the potential groups being connected.
3. If necessary, repeat step 2.
4. Reinsert the labeling strips.
The inserted bridges can be recognized by their labeling strips.
4.7 Replacing the terminal box on the terminal module
Introduction
The terminal box is part of the terminal module. If necessary, you can replace the terminal
box. It is not necessary to remove the terminal module.
Requirements
● The terminal module is installed, wired, and fitted with a COMPACTmodule, power
Required tools
Screwdriver with 3 mm blade
64
module, or electronic module.
Operating Instructions, 08/2008, A5E00515771-06
ET 200S