Siemens SIMATIC ET 200S Operating Instructions Manual page 33

Wiring and assembling ET 200S
1. Wire the ET 200S as shown below:
1
①
②
③
1. Use the PROFINET connector to connect the ET 200S (IO device) to the IO controller via
2. Insert the power and electronic modules into the terminal modules.
3. Switch on the power supply for the IO controller.
4. Observe the status LEDs on the IO controller.
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
2
24 VDC electronic power supply
24 VDC sensor supply potential group 1
24 VDC load supply potential group 2
a switch. The PROFINET interface is located on the IM 151-3 PN interface module.
CPU 317-2 PN/DP:
– DC 5V → lights up
– SF → off
– BF2 → off
Brief instructions on commissioning ET 200S
2.2 Commissioning on PROFINET IO
3
33