Siemens SIMATIC ET 200S Operating Instructions Manual page 129

FM approval
Factory Mutual Research (FM) according to
Approval Standard Class Number 3611, 3600, 3810
APPROVED for use in Class I, Division 2, Group A, B, C, D Tx;
Class I, Zone 2, Group IIC Tx
The ET 200S motor starters do not possess FM certification. All other modules of the
ET 200S are FM certified.
acc. to EN 50021 (Electrical apparatus for potentially explosive atmospheres; Type of
protection "n")
Personal injury and property damage can occur.
There is a risk of injury or damage if you disconnect any plug-in connections in potentially
explosive environments while the ET 200S is in operation.
Always de-energize the ET 200S in potentially explosive environments before
disconnecting plug-in connections.
Explosion Hazard
Components may no longer qualify for Class I, DIV. 2 if they are substituted.
This device is only appropriate for use in Class I, Div. 2, Group A, B, C, D, or in non-
hazardous areas.
Tick-Mark for Australia
The ET 200S distributed I/O system satisfies the requirements of the standard AS/NZS 2064
(Class A).
IEC 61131
The ET 200S distributed I/O system satisfies the requirements and criteria of the standard
IEC 61131-2 (Programmable Logic Controllers, Part 2: Equipment Requirements and Tests).
PROFIBUS standard
The ET 200S distributed I/O system is based on the
standard.
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
WARNING
WARNING
WARNING
General technical specifications
8.1 Standards and approvals
IEC 61784-1:2002 Ed1 CP 3/1
129