Wiring And Assembling Et 200S - Siemens SIMATIC ET 200S Operating Instructions Manual

Brief instructions on commissioning ET 200S
2.1 Commissioning on PROFIBUS DP
2.1.3

Wiring and assembling ET 200S

Proceed as follows
1. Wire the ET 200S as shown below:
①
②
③
1. Use the PROFIBUS bus connector to connect the DP master with the ET 200S. The
2. Insert the power and electronic modules into the terminal modules.
3. Switch on the supply voltage for the DP master.
4. Observe the status LEDs on the DP master.
24
1 2
24 VDC electronic power supply
24 VDC sensor supply voltage group 1
24 VDC load supply voltage group 2
PROFIBUS DP interface is located on the IM 151-1 STANDARD.
CPU 315-2 DP:
– 5 VDC → lights up
– SF DP → off
– BUSF → off
3
Operating Instructions, 08/2008, A5E00515771-06
ET 200S