Siemens SIMATIC ET 200S Operating Instructions Manual page 91

Wiring interface module IM151-1 FO STANDARD
1. Connecting the supply voltage:
2. Connecting PROFIBUS DP:
Pay attention to the correct position: The transmitter fiber optic cable is inserted into the
receiver female connector and the receiver fiber optic cable into the transmitter female
connector of the fiber optic cable interface of the IM151-1 FO STANDARD.
If the IM151-1 FO STANDARD interface module is the last node of the fiber-optic cable
network, the unoccupied fiber-optic cable interface must be blanked off (blanking plug
inserted in IM151-1 FO STANDARD, as supplied).
Do not look directly into the opening of the optical transmit diodes. The emitted light beam
could damage your eyes.
7
6
5
①
②
③
④
⑤
⑥
⑦
Figure 5-10
See also
Wiring rules for the ET 200S (Page 79)
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
– Strip the insulation from the supply voltage wires on the interface module.
– Secure the individual wires in the screw-type terminal.
– Insert the fiber-optic cable with the mounted plug adapters into the IM151-1 FO
STANDARD.
– Fold the protruding plug adapter grip upward.
CAUTION
ET 200S
Transmitter
Grip
Simplex connectors
Receiver
Supply voltage (1L+, 2L+, 1M, 2M)
Labeling strip
PROFIBUS DP (fiber-optic cable)
Wiring IM151-1 FO STANDARD
2
1
4 3
Wiring and assembly
5.4 Wiring the ET 200S
91