Table of Contents
Advertisement
Introduction
The SMARTBOX™ Controller
Major System Components
Parts Inspection
SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner's Manual - Rev14
The SMARTBOX™ Controller is a proprietary WindTronics control system that
consists of a charge controller and a non-grid-tie 1.5 kW inverter. Included within the
charge controller is an automatic AC transfer switch that will automatically switch
between your AC grid and power generated via the turbine.
The DC output from the turbine is fed into the Junction Box located beneath the
turbine assembly. The J Box serves three purposes: provide wiring interconnections
for the installation, provide an output over voltage protection of 170 VDC, and provide
a diversion or "dump" load that can dynamically brake and stop the turbine either
upon request from the SMARTBOX™ Controller or if a failure occurs in the system.
Beyond the J Box, all connections are fed into the SMARTBOX™ Controller. The
SMARTBOX™ Controller consists of four main elements: an I/O interface that
provides wiring interconnect for installation, a charge controller to charge a bank of
batteries, a non-grid-tie 1.5 kW inverter to back-convert the batteries to an AC output
and a transfer switch that can switch between AC grid input and the internal inverter's
AC.
SMARTBOX™ Controller
Batteries and battery enclosure
Upon opening the shipping container, review all contents to ensure the contents have
not been damaged during shipping and handling. Failure to properly inspect and
verify damages prior to installation may result in voiding of the manufacturer warranty.
If any turbine components appear to be damaged, please contact the WindTronics
service department at the following:
WindTronics, Inc.
Service Department
621 Sprucewood
Windsor, ON N9C0B3
Canada
1-877-946-3898
Get other manuals https://www.bkmanuals.com
2
Advertisement
Table of Contents
