Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 97

To remove: loosen the screws
#
out the tail lamps in the direction of the
arrow.
Remove the connector from the bulb mount
#
3.
Loosen the screws 2
#
mount 3 from the tail lamp.
Gently turn the bulb anti-clockwise and take it
#
out of the socket.
Insert the new bulb into the socket and turn it
#
clockwise.
To install: set the bulb mount
#
lamp and screw in the screws 2.
Press the connector into the bulb mount 3.
#
Insert the tail lamp and screw in the screws
#
1.
Licence plate lighting
Requirements:
Licence plate lighting: light bulb type W 5 W
R
Switch off the lighting system.
#
Place a screwdriver, for example, at the open‐
#
ing 2 between the lamp
1 and carefully prise off the lamp 3.
Remove the lamp 3
#
Rotate the bulb holder by around 45° and
#
detach it from the lamp.
Remove the light bulb.
#
Insert the new bulb into the bulb holder.
#
Insert the bulb holder into the lamp and
#
rotate it by around 45°.
Insert the lamp into the panel opening until it
#
engages.
Replacing rear light bulbs (chassis)
Overview of rear bulb types (chassis)
You can change the following bulbs.
1 and pull
and remove the bulb
3 on the tail
3 and the panel
from the panel 1.
Vehicles with standard tail lamps
1
Clearance lamp: R 5 W
2
Tail light: R 5 W
3
Brake light: P 21 W
4
Indicators: PY 21 W
5
Reversing lights: P 21 W
6
Rear fog light (driver's side): P 21 W
7
Licence plate lighting: R 5 W
Replacing the tail lamps on the chassis
Requirements:
Rear fog lights: bulb type P 21 W
R
License plate lighting: bulb type R 5 W
R
Reversing lights: bulb type P 21 W
R
Turn signal indicators: bulb type PY 21 W
R
Clearance lamp: bulb type R 5 W
R
Brake light: bulb type P 21 W
R
Taillight: bulb type R 5 W
R
95
Light and vision