Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 279

% Ring 8 of slider 4
angle of 90° to rack rail 2, so that slider
is engaged properly.
When the ring of the slider is at an angle
#
of 90° to the rack rail: pull ring
4 down and simultaneously move slider
to the desired position.
Release ring 8 at the desired position.
#
Move slider 4 slightly further along on rack
#
rail 2 until slider 4
When the ring of the slider is parallel to
#
the rack rail: move slider
position.
Position ring 8 of slider
#
90° to rack rail 2.
Slider 4 is engaged.
Adjusting the belt strap
Press and hold the locking mechanism on
#
slider 9.
Pull or release belt strap 5.
#
must always be at an
4
8 of slider
4
engages automatically.
4 to the desired
4 at an angle of
Release the locking mechanism on slider 9.
#
%
When securing or loosening a load, be sure
to not stand under the load.
Securing and loosening the load
To secure the load: place the load in the belt
#
straps of the rack rails.
Fasten the load flush with the partition.
#
Secure belt strap 5.
#
Check that the load is seated securely.
#
To loosen the load: press and hold the lock‐
#
ing mechanism on slider 9.
Pull ring 8 of the slider down and simultane‐
#
ously move the slider away from the load.
Loosen belt strap 5
#
make sure that the load does not fall out of
the belt straps.
Remove the load from the belt straps.
#
Fitting lashing eyelets
Turn the ring of lashing eyelet
#
parallel to the longitudinal axis of lashing eye‐
let C.
Hold lashing eyelet
#
ger and middle finger and place your thumb
through the ring of lashing eyelet
the central pressure point.
Use your thumb to push the locking pin down
#
as far as it will go.
Push lashing eyelet
#
the notches on rack rail
approximately 12 mm.
Remove your thumb from the pressure point
#
and slide lashing eyelet
Turn the ring of lashing eyelet
#
perpendicular to the longitudinal axis of lash‐
ing eyelet C.
Lashing eyelet C is secured.
Transporting 277
and at the same time
B until it is
C between the index fin‐
B and onto
C near the load through
2 and move it
C until it engages.
B until it is