Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 42

40
Occupant safety
If necessary, move the head restraint
#
upwards ( page 75).
/
Fit the ISOFIX child restraint system with Top
#
Tether. Comply with the child restraint system
manufacturer's installation instructions when
doing so.
Route the Top Tether belt
#
restraint between the two head restraint bars.
Hook the Top Tether hook
#
Tether anchorage 1
Tension the Top Tether belt 3. Comply with
#
the child restraint system manufacturer's
installation instructions when doing so.
If necessary, slide the head restraint down‐
#
wards ( page 75). Make sure that you do
/
not interfere with the correct routing of the
Top Tether belt 3.
Child restraint systems on the co-driver seat
Notes on a child restraint system on the co-
driver seat
Accident statistics show that children secured on
the rear seats are safer than children secured on
the front seats. For this reason, Mercedes-Benz
strongly advises that you fit a child restraint sys‐
tem to a rear seat.
Warning notice on the co-driver sun visor
NEVER use a rearward facing child restraint on a
seat protected by an ACTIVE AIRBAG in front of it,
DEATH or SERIOUS INJURY to the CHILD may
occur.
3 under the head
2 into the Top
without twisting.
Always observe the information on the safe trans‐
portation of children (
/
Notes on rearward-facing child restraint sys‐
tems
The sticker is visible when the co-driver door is
open:
The co-driver front airbag cannot be disabled.
This is indicated by a special sticker on the co-
driver side of the cockpit. Always fit a rearward-
facing child restraint system on a suitable rear
seat, but never on the co-driver seat.
Notes on forward-facing child restraint sys‐
tems on the co-driver seat
When using the child restraint system on the co-
driver seat, you must observe the following
points:
Set the co-driver seat to its rearmost position.
R
If on a seat with seat height adjustment, also
set the seat to its highest position.
Set the seat backrest to an almost vertical
R
position.
Retract the seat cushion length completely.
R
The base of the child restraint system must
R
lie fully on the co-driver seat cushion.
The backrest of a forward-facing child
R
restraint system must, as far as possible, lie
flat against the backrest of the co-driver seat.
The child restraint system must not touch the
roof or be put under strain by the head
restraints.
If necessary, adjust the angle of the seat
R
backrest and the position of the head
restraints accordingly.
Set the seat cushion angle in such a way that
R
the front edge of the seat cushion is in the
highest position and the rear edge of the seat
cushion is in the lowest position.
Always make sure that the shoulder belt strap
R
is correctly routed from the seat belt outlet of
page 36).