Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 341

%
Do not turn pressure release screw
than one or two full turns. Hydraulic fluid
could otherwise escape.
Insert pump lever 1
#
the recess on the jack and secure by turning
it clockwise.
Place the jack vertically beneath the jack sup‐
#
port points described below.
Jack support point, front axle
Jack support point, rear axle (example: plat‐
form vehicle up to 3.5 t)
3 more
with the largest rod into
Jack support point, rear axle (example: panel
van and crewbus up to 4.0 t)
Jack support point, rear axle (vehicles 5.0 t)
Place the jack beneath the jack support
#
point.
Vehicles with all-wheel drive: turn jack
#
spindle 2 anti-clockwise as far as it will go.
Raise the vehicle until the tyre is raised a
#
maximum of 3 cm off the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements:
The vehicle is raised (
R
When changing a wheel, avoid applying any
force to the brake discs since this could
impair the level of comfort when braking.
Wheels and tyres 339
page 339).
/
page 337).
/