Changing Bulbs - Mercedes-Benz Sprinter 2018 Operating Instructions Manual

92
Light and vision
Switching interior lighting delay time on/off
Multimedia system:
© Settings
4 5
Int. light. del. shut-off
5
Switching the lighting delay time on and off.
#

Changing bulbs

Instructions for changing bulbs
& WARNING Risk of burns from hot com‐
ponent parts whilst replacing a bulb
Bulbs, lamps and plug connectors can
become very hot during operation.
When replacing a bulb, you could burn your‐
self on these component parts.
Allow the component parts to cool
#
down before replacing the bulbs.
When you are replacing the light bulb, observe
the following:
Do not use any bulb that has been dropped or
R
has scratches on its glass tube. Otherwise,
the bulb may explode.
The bulb may explode if it is hot or if you
R
touch, drop or scratch it.
Stains on the glass tube reduce the bulb's
R
service life. Do not touch the glass tube with
your bare hands. If necessary, clean the glass
tube with alcohol or spirits in a cold state and
wipe it down with a lint-free cloth.
Protect bulbs from humidity and do not bring
R
them into contact with liquids.
Always ensure the bulbs are firmly secured.
If your vehicle is equipped with LED lamps, you
can check this as follows: the light cone will move
from top to bottom and back again when the
engine starts. For this to work, the dipped beam
needs to have been switched on before the
engine is started.
Bulbs and lights are a major part of vehicle
safety. Therefore, ensure that they are always
working. Have the headlamp setting checked reg‐
ularly.
Before changing the lamps, switch off the
R
vehicle's lighting system. This will prevent a
short circuit.
Use bulbs only in closed lights that have been
R
designed for them.
Lights
5
Use only spare bulbs of the same type and
R
with the correct voltage.
If the new bulb also does not light up, consult a
qualified specialist workshop.
Replacing front light bulbs (vehicles with hal‐
ogen headlamps)
Overview of front bulb types
You can change the following bulbs.
Halogen headlamps
1
Main beam/daytime running lights:
H15 55 W/15 W
2
Dipped beam/perimeter light: H7 55 W/
W 5 W
3
Indicators: PY 21 W
Changing the halogen headlamps
Requirements:
Dipped beam: light bulb type H7 55 W
R
High beam/daytime running lights: light
R
bulb type H15 55 W/15 W
Perimeter lights: light bulb type W 5 W
R
Turn signal indicators: bulb type PY 21 W
R