Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 304

302 Breakdown assistance
Remove breather hose
#
bracket from the connection on the degassing
cover.
Unscrew bolts 2 of bracket
#
bracket out upwards.
Slide the starter battery from its anchorage
#
across the direction of travel.
Fold the bars of the starter battery upwards
#
and lift the starter battery out of the battery
box.
Vehicles with front wheel drive: fitting the
starter battery
When reconnecting the starter battery,
#
observe the safety measures and protection
notes ( page 297).
/
Insert the starter battery into the battery box.
#
%
Take care that no wires are trapped.
Fold down the bars of the starter battery.
#
Slide the starter battery into its anchorage
#
across the direction of travel.
1 with the connector
3 and pull the
Insert bracket 3.
#
Tighten screws 2 on bracket
#
the battery in place.
Attach breather hose
#
bracket to the connection of the ventilation
cover.
Place the prefuse box on the battery.
#
Connect positive pole
#
Place the wires on the support bolt.
#
Tighten the nuts for wires
#
specified on prefuse box 5.
Mercedes-Benz recommends that you have the
starter battery replaced at a qualified specialist
workshop, e.g. a Mercedes-Benz Service Centre.
If you want to replace the starter battery yourself,
observe the following notes:
Always replace a defective starter battery
R
with a starter battery which meets the spe‐
cific requirements of the vehicle.
3 which holds
1 with the connector
A and close cover 7.
6 with torque