Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 332

330 Wheels and tyres
%
The values displayed in the multifunction dis‐
play may deviate from those of the tyre pres‐
sure gauge as they refer to sea level. At high
altitudes, the tyre pressure values indicated
by a pressure gauge are higher than those
shown by the on-board computer. In this
case, do not reduce the tyre pressures.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
Restarting the tyre pressure monitor
Requirements:
The recommended tyre pressure is correctly
R
set for the respective operating condition on
each of the wheels (
Restart the tyre pressure monitoring sys‐
R
tem in the following situations:
The tyre pressure has changed.
-
The wheels or tyres have been changed or
-
newly fitted.
On-board computer:
Service Tyres
4 5
Scroll down in the menu.
#
The Use current pressures as new reference
values? message appears in the multifunction
display.
Confirm the message to initiate a restart.
#
The Tyre press. monitor restarted
appears in the multifunction display.
Current warning messages are deleted and
the h yellow warning lamp goes out.
After you have driven for a few minutes, the
system checks whether the current tyre pres‐
sures are within the specified range. The cur‐
rent tyre pressures are then accepted as ref‐
erence values and monitored.
Make sure to observe the following further rela‐
ted subject:
Notes on tyre pressure (
R
page 314)
/
page 314).
/
message
page 314)
/
Radio-equipment approval of the tyre pres‐
sure monitoring system
Radio equipment approval numbers
Country Radio equipment approval
number
Argentina
CNC ID: H-20027
Australia
Brazil
MODELO: TSSRE4A
ANATEL: 05181-17-06643
Este equipamento opera em
caráter secundário, isto é, não
tem direito à proteção contrain‐
terferência prejudicial, mesmo de
estações do mesmo tipo e não
pode causar interferência a siste‐
mas operando em caráter pri‐
mário.
Canada IC: 4008C-TSSRE4A
Operation is subject to the follow‐
ing two conditions:
(1) this device may not cause
harmful interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.