Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 347

Assemble the pump lever for the jack and
#
slide it into sleeve 5
of spare wheel carrier 4.
Raise spare wheel carrier
#
lever and unhook right-hand safety hook 3.
Slowly lower spare wheel carrier
#
ground.
Lift spare wheel carrier
#
the pump lever out of the sleeve.
Use the pump lever to lift the spare wheel
#
beyond the rear edge of spare wheel carrier
4.
Carefully remove the spare wheel from spare
#
wheel carrier 4. The spare wheel is heavy.
When the spare wheel is removed, the centre
of gravity changes due to the heavy weight of
the wheel. The spare wheel may slip down or
tip over.
Vehicles with rear wheel drive: fitting the
spare wheel (panel van/crewbus)
Carefully place the spare wheel onto spare
#
wheel carrier 4. The spare wheel is heavy.
When you place the spare wheel onto spare
wheel carrier 4, the centre of gravity
changes due to the weight of the wheel. The
spare wheel may slip down or tip over.
Slide the pump lever for the jack into sleeve
#
5 on spare wheel carrier 4.
Raise spare wheel carrier
#
lever and attach right-hand safety hook 3.
Slightly raise spare wheel carrier
#
attach left-hand safety hook 3.
Pull the pump lever out of sleeve 5.
#
Using the wheel wrench, tighten safety hook
#
bolts 3 by turning them clockwise.
Replace and engage covers 1.
#
Close the rear-end doors.
#
on the right-hand side
4 with the pump
4 to the
4 slightly and pull
4 with the pump
4 and
Vehicles with rear wheel drive: removing the
spare wheel (vehicle with lowered chassis)
Bolt covers for the safety hooks (example: panel
van)
Open the rear-end doors.
#
Wheels and tyres 345