Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 95

1
High beam/daytime running lights housing
cover
2
Dipped beam/perimeter lights housing cover
3
Indicator socket
Switch off the lighting system.
#
High beam/daytime running lights: pull
#
back the housing cover 1.
Turn the socket anti-clockwise and pull it out.
#
Remove the bulb from the socket.
#
Insert the new bulb into the socket such that
#
the base of the bulb rests fully against the
base of the socket.
Insert the socket and turn it clockwise.
#
Attach the housing cover 1.
#
Dipped beam/perimeter lights: pull back
#
the housing cover 2.
Pull out the socket towards the rear.
#
Remove the bulb from the socket.
#
Insert the new bulb into the socket such that
#
the base of the bulb rests fully against the
base of the socket.
Align and insert the socket.
#
Attach the housing cover 2.
#
Turn signal indicator: switch off the lighting
#
system.
Turn the socket 3
#
remove it.
Gently turn the bulb anti-clockwise and take it
#
out of the socket.
Insert the new bulb into the socket and turn it
#
clockwise.
Insert the socket 3
#
anti-clockwise and
and turn it clockwise.
Additional turn signal light
Requirements:
Additional turn signal light (all-wheel
R
drive vehicles): bulb type P 21 W
Switching off the lighting system.
#
Unscrew the screws1
#
lens 2.
Gently turn the bulb to the left and take it out
#
of the socket.
Insert the new bulb into the socket and turn it
#
to the right.
Place the light lens2
#
the screws1.
Replacing rear light bulbs (panel vans and
crewbuses)
Overview of rear bulb types (panel van and
crewbus)
You can change the following bulbs.
93
Light and vision
and remove the light
in position and tighten