Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 58

56
Opening and closing
with obstacle detection at the front. If the step
meets an obstacle while extending, it stops.
When you have removed the obstacle, you must
first close the sliding door then re-open it so that
the step extends completely.
If the electrical step prevents loading, you can
block it via obstacle detection when the sliding
door opens. The electrical step then remains
retracted and a fork-lift truck or other lifting vehi‐
cle can move closer to the load area.
%
The display shows the
See Owner's Manual
not extended malfunction
When the ignition is switched off, a warning
tone sounds if obstacle detection is blocked.
The tone lasts two minutes.
When the ignition is switched on, the warning
tone sounds continuously.
Vehicles with an instrument display (colour
display): if the display shows the
ted See Owner's Manual
extended See Owner's Manual
warning tone sounds, electrical step
functioning ( page 383).
/
Vehicles with an instrument display (black
and white display): if the display shows the
step not retracted malfunction
not extended malfunction
tone sounds, electrical step
( page 383).
/
If electrical step 1 is malfunctioning, the step
may not extend or retract, or only partially. After
a malfunction occurs, you must retract and lock
electrical step 1 manually in order to continue
driving ( page 56). Before passengers exit the
/
vehicle, inform them that electrical step
be missing.
Step not extended
message or the step
message.
Step not retrac-
message or Step not
message and a
1 is mal‐
message or step
message and a warning
1 is malfunctioning
1 may
Releasing the electrical step in an emergency
(manual retraction)
If the electrical step does not automatically
retract, you must manually retract the step and
lock it in order to continue driving.
On the underside of step
#
remove the spring cotters
Remove the washers
#
bars.
2 on both bars 1
3 from the pin.
4 and detach both