Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 113

Activating the departure time
Activate the departure time by ticking the
#
box.
%
Ensure that A, B and C each correspond to a
programmed departure time.
%
The programmed time remains set only until
the next time the engine is started.
Problems with hot water auxiliary heating
Problem
FAIL¨
FAIL
FAIL¯
Auxiliary warm-air heater
Timer overview
1
Select option/change values
2
Menu bar
3
Select option
4
Press briefly to select or confirm a setting/
press and hold to switch immediate heating
mode on/off
Possible causes/consequences and
Signal transmission between transmitter and vehicle is malfunctioning.
Change your position in relation to the vehicle, moving closer if nec‐
#
essary.
The starter battery is not sufficiently charged.
Charge the starter battery.
#
The fuel tank is not filled up to the reserve level.
Refuel at the nearest filling station.
#
Auxiliary heating is malfunctioning.
Have the auxiliary heating checked at a qualified specialist work‐
#
shop.
Selecting programmed time
Set the required programmed time A, B or C.
#
%
The required programmed time A, B or C will
appear only if the box to activate the depar‐
ture time is ticked.
Select the required programmed time by
#
swiping left or right, e.g. A, B or C.
Solutions
M
5
Status bar
6
Press briefly to switch on the timer/cancel or
terminate the settings in a menu; press and
hold to terminate all functions
Setting the timer
Press the 6 button.
#
%
The timer will switch to standby mode after
ten seconds. The display will go off.
Setting the timer
Setting the time
You must reset the day, time and default value for
the operating duration in the following cases:
initial operation
R
after a voltage supply interruption (e.g.if the
R
battery has been disconnected)
after a malfunction
R
Press button 1 or
#
the menu bar 2.
Press the 4 button.
#
Press button 1 or
#
Press the 4 button.
#
Set the hour with button
#
Climate control 111
3 until 4 flashes on
3 until Î flashes.
1 or 3.