Mercedes-Benz Sprinter 2018 Operating Instructions Manual page 91

Always observe the traffic carefully and
#
switch off the main beam in good time.
The Adaptive Highbeam Assist automatically
switches between the following settings:
Dipped beam
R
High beam
R
The system detects that vehicle lights are
approaching in the opposite direction or driving
ahead of the vehicle.
At speeds greater than 30 km/h, a change is
made to the following setting:
If no other road users are detected, the high
R
beam switches on automatically.
At speeds less than 25 km/h or if there is suffi‐
cient road lighting, a change is made to the fol‐
lowing setting:
The high beam automatically switches off.
R
System limitations
Adaptive Highbeam Assist cannot take the road,
weather or traffic conditions into consideration.
The detection of obstacles can be restricted if:
visibility is impaired, e.g. in fog, heavy rain or
R
snow
the sensors are dirty or covered
R
Adaptive Highbeam Assist is only an aid. You are
responsible for ensuring correct vehicle lighting
in accordance with the prevailing light, visibility
and traffic conditions.
The system's optical sensor is located behind the
windscreen near the overhead control panel.
Switching Highbeam Assist on or off
To switch on: turn the light switch to position
#
Ã.
Switch the highbeam on using the combina‐
#
tion switch.
If the highbeam is automatically switched on
in darkness, the indicator lamp _ on the
multifunction display lights up.
To switch off: switch off the highbeam using
#
the combination switch.
Setting the exterior lighting switch-off delay
time
Requirements:
The light switch is in position Ã.
R
Multimedia system:
© Settings
4 5
Ext. light. del. shut-off
5
Setting a switch-off delay time.
#
When the vehicle engine is switched off, the exte‐
rior lighting will be activated for the set time.
Activating and deactivating the surround
lighting
Multimedia system:
© Settings
4 5
Surround lighting
5
Activate or deactivate the function.
#
The exterior lighting remains on for 40 seconds
after the vehicle is unlocked. When you start the
vehicle, the surround lighting will be deactivated
and the automatic driving lights activated.
Activating/deactivating the rotating beacon
& WARNING Risk of accident due to auto‐
matic deactivation of the rotating beacon
When the engine is switched off, the rotating
beacon will deactivate automatically as soon
as the on-board electrical system voltage
drops to a critical level.
Other road users will then no longer be
warned of the area of danger.
Use additional safety precautions, such
#
as a warning triangle, to warn other
road users.
Switching on the rotating beacon
89
Light and vision
Lights
5
Lights
5