3 Operational Differences
Installing the Column Inlet
Installing the Column Inlet
C A U T I O N
amFO"4F}^"¦F*FFm4ppdF=*Fdp§Q° :"m=^F4pd¤hmOdp§^"*FFmFp
1 Mount the column on the cage holder with the column label in
approximately the 12 o'clock position.
2 Remove the septum from the inlet end of the column.
Proper installation of the 6850A column nut (Part No. G2630-80720) requires at
least 10 cm of column inlet that can be vertically positioned without column
strain. If slight rotation of the column cage does not yield enough column inlet
length, it may be necessary to uncoil 1 loop at the inlet.
3 Slide the septum, column nut (Part No. G2630-80720) and appropriately
sized GC inlet ferrule onto the inlet end of the column.
The tapered end of the ferrule should point away from the column nut.
4 Use the column cutter (Part No. 5181-8836) to score the column 2 – 3 cm,
from the inlet end.
GQ¬mdF pd¤hm¤
Fz¤h
68
^azpam^F ^"*FFmzpzFd©¦FmF=:"dd
^F"F=«pmF|amdF:p¦Fm:"m=
"zadd"© pd¤hm
pd¤hm ¤F
F¤dF